Toro Power Max 724 OE - Adjusting the Discharge Chute Latch; Replacing the Drive Belts

Figure45
1.Spark-plugwire
3.Thumbscrew
2.Bracket
5.Cleanaroundthebaseofthesparkplug(Figure45).
6.Removeanddiscardtheoldsparkplug.
Note:Youwillneedaratchetwrenchextensionto
removethesparkplug.
7.Setthegapbetweentheelectrodesonanewsparkplug
at0.030inch(0.76mm)(Figure46).
Figure46
1.0.030inch(0.76mm)
8.Installthenewsparkplug,tightenitrmly,andattach
theignitionwiretothesparkplug.
9.Installthebracketwiththethumbscrewthatyou
removedinstep4.
10.Ensurethattheprimerbulbhoseandtheignitionwire
areconnectedandclearofthecarburetorbracket.
11.Securetheuppersnowhoodtothemachinewiththe2
screwsthatyoupreviouslyremoved.
12.Alignthetabonthechokecontrolknobwiththeslot
ontheuppersnowhood.
13.Connectthechokecontrolknobtothechokeshafton
thecarburetor.
AdjustingtheDischargeChute
Latch
Ifthedischargechutedoesnotlockintothedesiredposition
ordoesnotunlocksothatyoucanmoveittoanother
position,adjustthedischargechutelatch.
1.Loosentheclampfasteneronthechutesupportplate
untilthecableisfree.
g019021
1
2
3
Figure47
1.Cableconduit3.Clampfastener
2.Cableclamp
2.Removeanyslackinthecablebypullingthecable
conduitrearward.
3.Tightentheclampfastenerwhileholdingthecablein
place.
ReplacingtheDriveBelts
Iftheauger/impellerdrivebeltorthetractiondrivebelt
becomesworn,oil-soaked,orotherwisedamaged,havean
AuthorizedServiceDealerreplacethebelt.
25