Toro Precision Soil Sensor User Manual

5
Sensor Setup
Implement the following two procedures to successfully setup
Toro’s Precision™ Soil Sensor:
1. “Add” the sensor to the controller for successful wireless
communication.
2. Calibrate the sensor for proper irrigation operation.
1. Add the Sensor to the Controller
Every soil sensor has a unique
ID number. at number must
be “added” to the controller.
1. Press ADVANCED
then .
2. to ADD/REMOVE
DEVICE.
to conrm.
3. to SOIL 1. to ADD. to conrm.
4. e EVOLUTION® controller waits for the identication
signal from the soil sensor.
• If the soil sensor has had batteries installed in the last 30
minutes, the controller should detect and add the sensor
immediately.
• If the sensor is out in the eld, it could take up to a half
an hour to detect and add the sensor.
• One can remove and reinstall the soil sensor’s batteries to
achieve immediate sensor detection.
ZONE DETAILS
SCHEDULE STARTS
SCHEDULE DETAILS
SENSORS
ADVANCED
→
ADD/REMOVE DEVICE
→
WS ADD
SOIL 1 ADD
SOIL 2 ADD
SOIL 3 ADD
AUX 2 ADD
ADD/REMOVE DEVICE
→
ADD
INSTALL BATTERY OR
WAIT FOR SIGNAL
MAY TAKE 30 MINUTES
ADD/REMOVE DEVICE
CANCEL

Toro Precision Soil Sensor Specifications

General

Brand	Toro
Model	Precision Soil Sensor
Category	Accessories
Language	English