Toro ProStripe 560 - Adjusting the Cutting Height; Adjusting the Height of Cut

AdjustingtheCutting
Height
WARNING
Adjustingthecuttingheightmaybringyou
intocontactwiththemovingblade,causing
seriousinjury.
•Shutofftheengineandwaitforallmoving
partstostop.
•Donotputyourngersunderthehousing
whenadjustingthecuttingheight.
CAUTION
Iftheenginehasbeenrunning,themufer
willbehotandcanseverelyburnyou.
Keepawayfromthehotmufer.
AdjustingtheHeightofCut
1.Griptheheight-of-cutleverandpullsidewaysto
disengageitfromthelockingnotch(Figure11).
g281589
Figure11
1.Height-of-cutadjustinglever
2.Pushtheleverforwardtolowerorpullit
backwardtoraisetheheightofcut(Figure11).
3.Releasetheleverattherequiredpositionand
ensurethatitlocksrmlyinto1ofthe7setting
notches(Figure11).
HeightSettingHeightofCut
113.0mm
220.8mm
328.7mm
436.5mm
5
44.3mm
652.2mm
7
60.0mm
10