Toro Sand Pro 5040 - Installing the Hydraulic Cylinder

g028340
Figure16
Important:Ensurethattheexistinghoses
areroutedabovetheguide,asshownin
Figure16.
8
InstallingtheHydraulic
Cylinder
Partsneededforthisprocedure:
1
45°hydraulicttingwithO-ring
1Hydrauliccylinder
1
90°hydraulicttingwithO-ring
1
Smallretainingring
1Pin
2Largeretainingring
Procedure
1.Threada90°ttingintotheupperportinthe
hydrauliccylinder.Positionthettingasshown
inFigure17.
Note:MakesurethatallO-ringsarelubricated
andproperlypositionedonttingsbefore
installation.
Note:T opreventcontaminationtothehydraulic
ttingsorhoses,donotremovethecapsfrom
thettingsorhosesuntiltheyareinstalled.
2.Threada45°ttingintothelowerportinthe
hydrauliccylinder.Positionthettingasshown
inFigure17.
g003669
Figure17
1.Hydrauliccylinder
3.45°tting
2.90°tting4.Plug(1/8inch)
3.Mountthetopofthehydrauliccylinderbarrel
tothepinontheright-handplowplatewitha
retainingring(Figure18).
Note:Positionthecylinderhydraulicports
forward.
g028342
Figure18
1.Retainingring4.Pusharmstrap
2.Hydrauliccylinder5.Pin
3.Pin(onplowplate)
4.Mountthecylinderrodtothepusharmstraps
withapinand2retainingrings(Figure18).
10