Toro Sand Pro 5040 - Installing Hydraulic Hoses (Model 08705)

9
InstallingtheHydraulic
Hoses
Model08705Only
Partsneededforthisprocedure:
1Tubeassembly
1
Hydraulichose(PartNo.108-8449)
1
Hydraulichose(PartNo.108-8453)
1
Hydraulichose(PartNo.108-8454)
1Wirehoseholder
2
Threadformingscrew(5/16x3/4inch)
3Plasticcabletie
Procedure
1.Connectthetubeassembly(PartNo.108-8447)
tothe90°ttingontheleftsideofthenewvalve
andthevacatedttingontheexistingliftvalve
(Figure19).
2.Connectthe45°ttingendofhydraulichose
(PartNo.108-8449)tothe90°ttingontheright
sideofthevalveandthestraightendofthehose
tothevacantoilcoolertting(Figure19).Refer
toFigure20andFigure21forhoserouting.
3.Mountthewirehoseholdertotheleftframetube
with2thread-formingscrews(5/16x3/4inch);
refertoFigure19.
4.Connecttheshort90°ttingendofhydraulic
hose(PartNo.108-8453)tothetopstraight
ttingontherearofthevalve.Routethehose
throughthewirehoseholderandconnectthe
straightendofthehosetothetophydraulic
cylindertting(Figure19).RefertoFigure20
andFigure21forhoserouting.
5.Connectthelong90°ttingendofthehydraulic
hose(PartNo.108-8454)tothebottomstraight
ttingontherearofthevalve.Routethehose
throughthewirehoseholderandconnectthe
straightendofthehosetothebottomhydraulic
cylindertting(Figure19).RefertoFigure20
andFigure21forhoserouting.
Important:Ensurethatthehosesare
routedawayfromanysharp,hot,ormoving
components.
6.Tightenallfastenersandttings.
7.Usingcableties,securethehosestothe
machineatthelocationsshowninFigure20and
Figure21.
g003672
Figure19
Model08705
1.Newvalve3.Existingvalve5.Wirehoseholder
7.Hydraulichose(PartNo.
108-8454)
2.Tubeassembly(PartNo.
108-8447)
4.Hydraulichose(PartNo.
108-8449)
6.Hydraulichose(PartNo.
108-8453)
11