Toro SGR-6 - Page 12

g025887
Figure10
1.Pivotpoint2.Pivotpointwhenthe
parkingbrakeisengaged
3.Movethemachinetothefrontofthestumpand
engagetheparkingbrake.
4.MovethrottleuptotheENGAGEposition.The
cuttingwheelwillbeginrotating.
5.Swingthecuttingwheeltooneside(Figure10),
thenloweritapproximately1to2.5cm(1/2to1
inch)intothefront-topcornerofthestump.
g024062
Figure11
6.Usingasweepingmotion,swingthecutting
wheelbackandforth,loweringthecuttingwheel
approximately1to2.5cm(1/2to1inch)before
eachsweep,untilyouhaveremovedthefront
portionofthestumptogroundlevel(Athrough
DinFigure11).
7.Raisethecuttingwheel,releasetheparking
brake,andmovethemachineforwardafew
centimeters(inches).Engagetheparkingbrake.
8.Repeatsteps5and7untilyouhavecompletely
removedthestump(EthroughHinFigure11).
9.MovethrottletotheDISENGAGEposition,push
thehandledownenoughtoraisethecutting
wheelofftheground.Waitforthecuttingwheel
tostoprotatingthenreleasetheparkingbrake
andpullthemachineawayfromthestump.
Note:Donotletthefrontofthemachinetouch
thegrounduntilthecuttingwheelhasstopped
turning.
10.Shutofftheengine;refertoShuttingOffthe
Engine(page11).
12