Toro SnowMaster 724 ZXR - Replacing the Spark Plug; Spark Plug Replacement; Adjusting the Auger Cable; Auger Cable Adjustment

Figure18
1.Lowoillevel—addoil
2.Correctoillevel
B.Installthedipsticksecurely.
ReplacingtheSparkPlug
ServiceInterval:Every100hours—Replacethesparkplug.
WARNING
Replacingthesparkplugwhiletheengineishot
canresultinburns.
Waituntiltheengineiscooltoreplacethespark
plug.
UseaTorosparkplugorequivalent(Champion®RN9YCor
NGKBPR6ES).
1.Removetheboot(Figure19).
Figure19
1.Spark-plugboot
2.Cleanaroundthebaseofthesparkplug.
3.Removeanddiscardtheoldsparkplug.
Note:Youwillneedaratchetwrenchextensionto
removethesparkplug.
4.Setthegapbetweentheelectrodesonanewsparkplug
at0.76mm(0.030inch)asshowninFigure20.
Figure20
1.0.76mm(0.030inch)
AdjustingtheAugerCable
ServiceInterval:Aftertherst2hours
Yearly
Ifthedrivebeltslipsorsquealsunderheavyload,adjustthe
augercable.
1.Loosenthenutonthelowercableclamp,butdonot
removeit(Figure21).
Figure21
1.Nut
3.Connector
2.Cable4.Spring
2.Pullthecableuptoremovesomeslack(Figure21).
Important:Donotremovealltheslackfrom
thecable.Removingalltheslackfromthecable
preventstheaugerfromstoppingproperly.
3.Holdthecableinplaceandtightenthenut(Figure21).
14