Toro Super Recycler 20062 - Starting the Engine; Adjusting the Handle Height

Figure 14
Adjusting the Handle Height
Y ou ma y raise or lo w er the handle to a position comfor table
for y ou.
1. R emo v e the lo w er handle knobs that attac h the handle
brac k ets to the lo w er handle ends ( Figure 15 ).
Figure 15
2. Inser t the bolt through the hole in eac h of the handle
brac k ets that sets the handle to the desired position
( Figure 16 ).
Figure 16
1. Highest position
3. Lowest position
2. Middle position (either
hole)
3. Install the lo w er handle knobs and tighten the knobs as
tight as y ou can b y hand ( Figure 17 ).
Figure 17
Starting the Engine
1. Fir mly push in the primer 3 times with y our thumb ,
holding the primer in for a second before releasing it
eac h time ( Figure 18 ).
Figure 18
Note: If the air temperature is belo w 55°F (13°C),
fir mly push the primer in 5 times .
2. Pull the blade control bar to the handle ( Figure 19 ).
Figure 19
3. T ur n the ignition k ey ( Figure 20 ) or pull the recoil star t
handle ( Figure 21 ).
Figure 20
8