Toro TimeCutter 74774 - Pre-Maintenance Procedures; Raising the Seat; Lubrication; Greasing the Bearings

Pre-Maintenance
Procedures
RaisingtheSeat
Ensurethattheparkingbrakeisengaged.Liftthe
seatforward.
Youcanaccessfollowingcomponentsbyraisingthe
seat:
•Serialplate
•Servicedecal
•Seat-adjustmentbolts(ifapplicable)
•Fuellter
•Batteryandbatterycables
Lubrication
GreasingtheBearings
AllModelswithoutMyRide
ServiceInterval:Every25hours—Greaseall
lubricationpoints(non-MyRide
modelsonly).
GreaseType:No.2lithiumgrease
1.Disengagetheblade-controlswitch(PTO),move
themotion-controlleverstotheNEUTRAL-LOCK
position,andengagetheparkingbrake.
2.Shutofftheengine,removethekey,andwait
forallmovingpartstostopbeforeleavingthe
operatingposition.
3.Cleanthegreasettings(Figure36andFigure
37)witharag.
Note:Makesuretoscrapeanypaintoffthe
frontofthetting(s).
g032432
Figure36
1.Frontcastertire
decal106-8717
Figure37
Locatedontheseat-panunderside
1.Readtheinstructions
beforeservicingor
performingmaintenance.
3.Greaseevery25operating
hours.
2.Checkthetirepressure
every25operatinghours.
4.Engine
4.Connectagreaseguntoeachtting(Figure36
andFigure37).
5.Pumpgreaseintothettingsuntilgreasebegins
tooozeoutofthebearings.
37