Toro TimeCutter Z380 - User Manual

Questions and Answers:

J
jerryhallSep 13, 2025
How to stop abnormal vibration in Toro TimeCutter Z380?
- E
  elarsonSep 13, 2025
  Abnormal vibration in your Toro Lawn Mower can stem from several issues. Start by checking the engine mounting bolts and tighten them if they are loose. Inspect the engine pulley, idler pulley, or blade pulley and tighten any that are loose. If the engine pulley is damaged, contact an Authorized Service Dealer. Also, inspect the cutting blades. If the cutting blade(s) is/are bent or unbalanced, install a new cutting blade(s). Ensure that the blade mounting bolt is tightened. If a blade spindle is bent, contact an Authorized Service Dealer.
M
Mary MartinezSep 15, 2025
Why is my Toro TimeCutter Z380 Lawn Mower engine overheating?
- B
  Bonnie ByrdSep 16, 2025
  If your Toro Lawn Mower engine overheats, there are several potential causes. First, the engine load might be excessive, in which case you should reduce ground speed. Second, the oil level in the crankcase could be low, so you should add oil. Third, the cooling fins and air passages under the engine blower housing might be plugged; remove any obstructions. Fourth, a dirty air cleaner could be the issue; clean or replace the air cleaner element.
D
Douglas EspinozaSep 18, 2025
What causes the blades on my Toro TimeCutter Z380 Lawn Mower to not rotate?
- A
  Adam HodgeSep 18, 2025
  If the blades on your Toro Lawn Mower do not rotate, install a new drive belt if the current one is worn, loose, or broken. If the drive belt is off of the pulley, install the drive belt and check the adjusting shafts and belt guides for the correct position. Also, install a new mower belt if the current one is worn, loose, or broken.

Toro TimeCutter Z380 Specifications

General

Engine Power	24 HP
Engine Displacement	725 cc
Deck Type	Fabricated
Deck Material	Steel
Transmission	Hydrostatic
Speed	Up to 7 mph
Turning Radius	Zero-Turn
Spindle Material	Aluminum
Cutting Width	38 in
Cutting Height	1.5 - 4.5 in
Fuel Capacity	3 gallons
Blade Tip Speed	18, 500 ft/min