Driving Forward or Backward
The throttle control regulates the engine speed as
measured in rpm (revolutions per minute). Place
the throttle control in the Fast position for best
performance. Always operate in the full throttle
position.
The machine can spin very rapidly. The
operator may lose control of the machine
and cause personal injury or damage to the
machine.
• Use caution when making turns.
• Slow the machine down before making
sharp turns.
Figure 16
1 2
2 1
/
3
Figure 15
1. Park (brake) position 3. Forward
2. Center unlock position 4. Backward
4
G004532
Forward
1. Move the levers to the center, unlocked position.
2. To go forward, slowly push the motion control
levers forward (Figure 15).
To go straight, apply equal pressure to both motion
control levers (Figure i5).
To turn, release pressure on the morion control lever
toward the direction you want to turn (Figure 15).
The farther you move the motion control levers in
either direction, the faster the machine will move in
that direction.
To stop, pull the motion control levers to neutral.
Backward
1. Move the levers to the center, unlocked position.
2. To go backward, slowly pull the morion control
levers rearward (Figure 17).
I$1
G008953
Figure 17
To go straight, apply equal pressure to both motion
control levers (Figure 17).
18
To Next Page
Loading...
