.
.
.
.
.
G005278
2\
Figure 47
Mower Decks with 3 Blades
1. Blades side to side 3. Outside cutting edges
2. Sail area of blade 4. Measure from the tip of the
blade to the flat surface
here
Measure between the outside cutting edges and
the flat surface (Figure 46 and Figure 47). If both
measurements are not within 3/i6 inch (5 ram), an
adjustment is required; continue with this procedure.
Move to the left side of the machine. Loosen, but
do not remove, the rear locldng nut on the hanger
bracket (Figure 48).
Loosen the side locking nut on the hanger bracket
just enough to allow the eccentric plate to be adjusted
(Figure 48). Use a 3/8 inch drive extension on a
socket wrench to manipulate the eccentric plate. Use
the wrench to reposition the height of the mower
deck and adjust to the desired height.
Stop the deck at the adjusted position and tighten the
side locking nut on the hanger bracket to hold the
new position (Figure 48). Tighten the rear locking
nut on the hanger bracket.
Continue leveling the deck by checking the
front-to-rear blade slope; refer to Adjusting the
Front-to-Rear Blade Slope.
1
6
5
G005074
2
Figure 48
1. Hanger bracket 4. Eccentric adjustment plate
2. Rear locking nut 5. Socket wrench hole
3. Side locking nut 6. Socket wrench with 3/8
inch extension
Adjusting the Front-to-Rear Blade
Slope
Check the front-to-rear blade level any time you install
the mower. If the front of the mower is more than
5/16 inch (7.9 ram) lower than the rear of the mower,
adjust the blade level using the following instructions:
1. Park the machine on a level surface and disengage
the blade control switch.
. Move the motion control levers outward to the
park position, stop the engine, remove the ke3; and
wait for all moving parts to stop before leaving the
operating position.
3. Set the height-of-cut lever to middle position.
.
Note: Check and adjust the side-to-side blade
level if you have not checked the setting; refer to
Side-to-Side Leveling.
Carefully rotate the blades so they are facing front to
rear (Figure 49 and Figure 50).
37
To Next Page
Loading...
