Toro TimeCutter ZX 18-52 User Manual (English)

Questions and Answers:

K
Kevin HortonAug 7, 2025
How to fix a Toro TimeCutter ZX 18-52 that does not drive/track straight?
- K
  Kristy OdonnellAug 7, 2025
  If your Toro Lawn Mower doesn't drive or track straight, start by checking the tire inflation; inflate to the recommended pressure and ensure tire diameters are approximately equal from side to side. Also, a bent, loose, or misaligned control linkage could be the culprit; repair, adjust, or replace the vehicle linkage. Finally, examine the bypass linkage and adjust it as necessary.
C
Christopher HillAug 12, 2025
What to do if the transaxle of my Toro TimeCutter ZX 18-52 leaks oil?
- C
  Cynthia WellsAug 13, 2025
  If the transaxle of your Toro Lawn Mower is leaking oil, it could be due to damaged seals, housing, or gaskets, which would need to be replaced. Alternatively, air trapped in the hydraulic system could be the cause, requiring you to purge the hydraulic system.
M
Maria FitzpatrickAug 22, 2025
Why is my Toro Lawn Mower so noisy?
- A
  Andrea JohnsAug 22, 2025
  There are several reasons why your Toro Lawn Mower might be noisy. It could be due to a low oil level or contaminated oil, in which case you should fill it to the proper level or change the oil. Excessive loading can also cause noise, so reduce the vehicle loading. An incorrect brake setting might be the issue, so adjust the brake to the proper setting. Loose parts can also generate noise, and they should be repaired or replaced. A sticking bypass assembly can contribute to the noise, requiring repair or replacement of the valve or linkage. Finally, air trapped in the hydraulic system can also cause noise, so consider purging the hydraulic system.
S
Stephen GentryAug 27, 2025
What to do if my Toro TimeCutter ZX 18-52 is operating hot?
- P
  pcarterAug 27, 2025
  If your Toro Lawn Mower is operating hot, it could be due to debris buildup around the transaxle; clean off any debris. An incorrect brake setting can also cause overheating, so adjust the brake to the proper setting. A damaged cooling fan should be repaired or replaced. Check the oil level, as low or contaminated oil can lead to overheating; fill to the proper level or change the oil. Reduce vehicle loading. Finally, air trapped in the hydraulic system can cause the unit to run hot, so you may need to purge the hydraulic system.
R
Ricky RojasSep 1, 2025
Why does my Toro Lawn Mower only operate in one direction?
- J
  Judith OsborneSep 1, 2025
  If your Toro Lawn Mower operates in only one direction, it may be caused by a bent or misadjusted control linkage, which would need to be repaired or replaced. Another possible cause is a slipping drive belt or damaged pulley, which also requires repair or replacement.