Adjusting the Cutting Height
DANGER
Adjusting the cutting-height levers could bring your hands into contact with a moving blade
and result in serious injury .
• Shut off the engine, remove the ignition key (if equipped), and wait for all moving parts to
stop before adjusting the cutting height.
• Do not put your ngers under the housing when adjusting the cutting height.
CAUTION
If the engine has been running, the mufer will be hot and can burn you.
Keep away from the hot mufer .
Note: T o raise the machine, move the front and rear cutting-height levers forward; to lower the machine,
move the cutting-height levers rearward. Set all the wheels to the same height unless special circumstances
require otherwise.
g454727
Figure 13
12
To Next Page
Loading...
