Checking the Blade-Stop
System Operation
Service Interval : Before each use or daily
Check that the blades stop within 3 seconds of
releasing the blade-control bar .
Using the Grass Bag
Y ou can use the grass bag to check the blade-stop
system.
1. Remove the rear-discharge plug.
2. Install the empty grass bag on the machine.
3. Start the engine.
4. Engage the blades.
Note: The bag should begin to inate, indicating
that the blades are rotating.
5. While watching the bag, release the
blade-control bar .
Note: If the bag does not deate within 3
seconds of releasing the blade-control bar , the
blade-stop system may be deteriorating and,
if ignored, could result in an unsafe operating
condition. Have the machine inspected and
serviced by an Authorized Service Dealer .
6. Shut of f the engine and wait for all moving parts
to stop.
Not Using the Grass Bag
1. Move the machine onto a paved surface in a
non-windy area.
2. Set all 4 wheels to the 89 mm (3-1/2 inch) cutting
height setting.
3. T ake a half sheet of newspaper and crumple it
into a ball small enough to go under the machine
housing (about 76 mm (3 inches) in diameter).
4. Place the newspaper ball about 13 cm (5 inches)
in front of the machine.
5. Start the engine.
6. Engage the blades.
7. Release the blade-control bar and begin
counting out 3 seconds.
8. On the count of 3, push the machine quickly
forward over the newspaper .
9. Shut of f the engine and wait for all moving parts
to stop.
10. Go to the front of the machine and check the
newspaper ball.
Note: If the newspaper ball did not go under
the machine, repeat steps 4 through 10 .
1 1. If the newspaper is unravelled or shredded, the
blades did not stop properly , which could result
in an unsafe operating condition. Contact an
Authorized Service Dealer .
Recycling the Clippings
This machine comes from the factory ready to recycle
grass and leaf clippings back into the lawn. T o prepare
the machine to recycle, do the following:
• If the side-discharge chute is on the machine,
remove it and lower the side-discharge deector;
refer to Removing the Side-Discharge Chute
( page 19 ) .
• If the grass bag is on the machine, remove it; refer
to Removing the Grass Bag ( page 18 ) .
• If the rear-discharge plug is not installed, grip it by
the handle, raise the rear deector , and insert it
into the rear-discharge chute until the latch locks
into place; refer to Figure 22 .
g234924
Figure 23
W ARNING
Operating the machine to recycle lawn
clippings without the plug in place allows
objects to be thrown toward you or
bystanders. Also, contact with the blades
could occur . Thrown objects or blade contact
can cause serious injury or death.
Ensure that the rear-discharge plug is in
place before you recycle the clippings.
Never engage the blades without either the
rear-discharge plug or the grass bag installed
on the machine.
17
To Next Page
Loading...
