Engine-Oil Service (continued)
G027477s
6. Slowly pour approximately 80% of the specified oil into the filler tube and slowly add the
additional oil to bring it to the Full mark.
G365790s
7. Dispose of the used oil at a recycling center.
Servicing the Spark Plug
Ensure that the air gap between the center and side electrodes is correct before installing
the spark plug. Use a spark plug wrench for removing and installing the spark plug and a
gapping tool or feeler gauge to check and adjust the air gap. Install a new spark plug if
necessary.
Type: Champion® XC12YC
Air gap: 0.76 mm (0.03 inch)
Removing the Spark Plug
1. Park the machine on a level surface, disengage the blade-control switch, and move the
motion-control levers outward to the P
ARK position.
2. Shut off the engine, remove the key, and wait for all moving parts to stop before leaving
the operating position.
3464-634A Page 5–9 Maintenance: Engine Maintenance
To Next Page
Loading...
