Toro TITAN HD 2000 Series - Replacing the Hydraulic Pump-Drive Belt

ReplacingtheHydraulic
Pump-DriveBelt
1.Parkthemachineonalevelsurface,disengage
theblade-controlswitch(PTO),andengagethe
parkingbrake.
2.Shutofftheengine,removethekey,andwait
forallmovingpartstostopbeforeleavingthe
operatingposition.
3.Removethemowerbelt;refertoReplacingthe
MowerBeltforSide-DischargeMowerDecks
(page66)orReplacingtheMowerBeltfor
Rear-DischargeMowerDecks(page67).
4.Raisethemachineandsupportitwithjack
stands(Figure102).
5.Removetheclutchstop(Figure101).
g036860
Figure101
1.Clutchstop
6.Removetheidlerspringfromthepost(Figure
102).
7.Removetheexistingbeltfromthe
hydraulic-pump-drivepulleysandthe
enginepulley.
8.Installthenewbeltaroundtheenginepulleyand
the2hydraulic-pumppulleys(Figure102).
g036859
Figure102
1.Idlerpulley4.Pump-drivebelt
2.Idler-springpost5.Righthydraulic-pump
pulley
3.Enginepulley
6.Lefthydraulic-pumppulley
9.Installtheclutchstop(Figure101).
10.Installthemowerbelt;refertoBeltMaintenance
(page66).
69