Workman HD Series Page 6 − 5 Drive Train
Adjustments
Power−Take−Off (PTO) Cable Adjustment (If Equipped)
1. Remove clevis pin that secures PTO cable to PTO le-
ver arm.
2. Loosen clevis jam nut and adjust clevis so clevis hole
aligns with hole in PTO lever arm.
3. Tighten jam nut making sure that holes in clevis and
lever arm still align.
4. Secure PTO cable clevis to PTO lever arm with clevis
pin.
1. PTO lever arm
2. PTO cable
3. Clevis pin
4. Clevis jam nut
Figure 3
1
2
3
4
Drive Train
To Next Page
Loading...
