g027950
Figure 34
1. Fuse block
2. Ground block
1 1
Installing the Dash Support
Parts needed for this procedure:
1 Back plate
1 Adjuster plate
1
T ap bolt (1/2 x 4 inches)
1
Flange nut (1/2 inch)
1
Stop plate
4
Carriage bolt (1/4 x 1-3/4 inches)
4
Flange nut (1/4 inch)
Procedure
1. Measure 20.7 cm (8-1/8 inches) to the left from
the bottom edge of the hood bracket and mark
the location ( Figure 35 ).
g246001
Figure 35
1. 20.7 cm (8-1/8 inches)
2. Install the adjuster plate and back plate to the
dash-support tube using the 4 carriage bolts
(1/4 x 1-3/4 inches) and ange nuts (1/4 inch)
as shown in Figure 36 .
g245999
Figure 36
1. Carriage bolt (1/4 x 1-3/4
inches)
3. Flange nut (1/4 inch)
2. Adjuster plate 4. Back plate
3. Install the tap bolt (1/2 x 4 inches), ange nut
(1/2 inch), and stop plate to the adjuster plate
( Figure 37 ).
15
To Next Page
Loading...
