g246000
Figure 37
1. Stop plate
3. Adjuster plate
2. Flange nut (1/2 inch) 4. T ap bolt (1/2 x 4 inches)
4. Close the gap between the dash and cab by
adjusting the tap bolt (1/2 x 4 inches) until the
stop plate pushes upward on the dash ( Figure
38 ).
g246149
Figure 38
1. Gap between the dash and cab
12
Installing the W ater Gutter
Parts needed for this procedure:
1 W ater gutter
1
Passenger ’ s side clear tube—122 cm (48 inches)
1
Driver ’ s side clear tube—43 cm (17 inches)
1
Floor clear tube—33 cm (13 inches)
1
T ee tting
3 Magnetic tie-wrap mount
3
Cable tie
Procedure
1. Remove the 5 hex-washer head bolts from the
dash ( Figure 39 ).
Retain the 5 hex-washer head bolts.
g245854
Figure 39
1. Dash 2. Hex-washer head bolt
2. Slide the water gutter between the machine
dash and sub-frame and secure the water gutter
using the previously removed 5 hex-washer
head bolts ( Figure 40 ).
16
To Next Page
Loading...
