Toro Workman HDX - Page 18

7. Pinch each end of the clear tube and cut it at a
45° angle ( Figure 44 ).
8. Align the clear tube with the bottom of the water
gutter so that the top of the angle is to the
outside of the machine and install it ( Figure 44 ).
g246160
Figure 44
1. T ube cut at a 45° angle and installed at the bottom edge of
the water gutter
13
Installing the Floor and
Side-Plate Panels
Parts needed for this procedure:
2 Floor-plate panel
2
Side-plate panel
12
Bolt (1/4 inch)
Procedure
1. Install the oor-plate panels on each side of
the machine using 3 bolts (1/4 inch) as shown
in Figure 45 .
g026248
Figure 45
1. Bolt (1/4 inch)
2. Floor-plate panel
2. T orque the bolts to 1017 to 1243 N∙cm (90 to
1 10 in-lb).
3. Install the side-plate panels on each side of the
machine using 2 bolts (1/4 inch) as shown in
Figure 46 .
g026249
Figure 46
4. T orque the bolts to 1017 to 1243 N∙cm (90 to
1 10 in-lb).
14
Installing the Center
Console Panel, Seats,
Coolant T ank, CVT -Cooling
Duct (HDX-Auto Machines
only), and Operator ’ s
Manual T ube
Parts needed for this procedure:
2
Bolt (1/4 inch)
2
Spacer
1
Strap
2
Nut (1/4 inch)
1
CVT -intake hood assembly (sold separately)
Procedure
1. Install the Operator ’ s Manual tube ( Figure 47 ).
18