Workman MD/MDXPage 7 -- 24Chassis
Installation (Fig. 13)
1. Position swing arm to engine tray assembly.
2. Make sure that isolation mounts are positioned in the
swing arm so that the flange is positioned between the
swing arm bracket and engine tray location (Fig. 15).
3. Secure engine tray to the swing arm with cap screws,
flat washers and flange nuts (Fig. 14).
4. Secure transaxle to swing arm with four (4) cap
screws and flat washers (Fig. 14).
IMPORTANT: Take care to not damage the engine,
transaxle, fuel hoses, electrical harness or other
parts while raising the swing a rm and engine tray
assembly.
5. Carefully, raise swing arm and engine tray assembly
to the machine frame. Align swing arm pivots to frame
mounting points.
6. Secure swing arm to machine frame with cap
screws, thrust washers and lock nuts. Torque lock nuts
from 70 to 90 ft--lb (95 to 122 N--m).
7. Secure both shock absorbers to swing arm with cap
screw and lock nut. Insert cap screw from the inside of
the swing arm brackets.
8. Lower machine to ground.
9. Connect parking brake cables to rear brake levers
and swing arm.
10.Install muffler to machine ( see Exhaust System
Installation in the Service and Repairs section of Engine
Chapter).
11. Lower and secure cargo box.
12.Check parking brake operation and adjust if neces-
sary (see Adjust Parking Brake in the Adjustments sec-
tion of this chapter).
To Next Page
Loading...
Need help?
General
