Workman MD/MDX
Drive Train
Page 5 -- 28
1. Ball bearing 2. Input shaft
Figure 40
1
2
IMPORTANT: Do not reuse ball bearings that have
been removed.
B. Remove ball bearing from the input shaft with a
bearing puller.
1. Governor plate assembly 2. Governor base
Figure 41
1
2
IMPORTANT: Make sure to not damage the screw
heads when removing screws. Each screw is se-
cured with an adhesive.
C. On Workman MD, remove two (2) screws and
lock pin securing the governor plate assembly to the
governor base.
To Next Page
Loading...
