Toro Z Master G3 - Controls System Maintenance; Adjusting the Control Handle Position

Figure79
1.Idlerpulley
5.Lefthandhydraulicpump
pulley
2.Clutchpulley6.Squareholeinidlerarm
3.Pumpdrivebelt7.Idlerspring
4.Righthandhydraulicpump
pulley
5.Usearatchetinthesquareholeintheidlerarmto
removetheidlerspring(Figure79).
6.Unhooktheidlerspringfromtheframe(Figure79).
7.Removethebeltfromthehydraulicunitdrivepulleys
andtheenginepulley
8.Installthenewbeltaroundenginepulleyandthe
twodrivepulleys.
9.Usingaratchetinthesquareholeintheidlerarm,
installtheidlerspringtotheframe(Figure79).
10.Installthemowerbelt.RefertoReplacingthe
MowerBelt.
ControlsSystem
Maintenance
AdjustingtheControlHandle
Position
Therearetwoheightpositionsforthecontrollevers;
highandlow.Removetheboltstoadjusttheheightfor
theoperator.
1.DisengagethePTO,movethemotioncontrollevers
totheneutrallockedposition,andsettheparking
brake.
2.Stoptheengine,removethekey,andwaitforall
movingpartstostopbeforeleavingtheoperating
position.
3.Loosentheboltsandangenutsinstalledinthe
levers(Figure80).
4.Aligntheleversfronttorearpositionbybringthe
leverstogethertotheneutralpositionandslide
themuntiltheyarealigned,thentightenthebolts
(Figure81).
Figure80
1.Bolt
3.Controllever
2.Handle4.Nut
52