Figure 20
1. Outer roller
4. Nut
2. Stud
5. Wheel nut and washer (do
not remove)
3. Washer
Note: Do not remo v e the wheel n ut and
w asher ( Figure 20 ).
4. Select a hole so that the outer roller is
positioned to the nearest cor responding
height-of-cut desired ( Figure 20 ).
5. Install the stud n ut and w asher ( Figure 20 ).
6. R e peat this adjustment on the other rollers .
Adjusting the Center Rollers
1. Diseng ag e the PTO , mo v e the motion control
lev ers to the neutral loc k ed position, and set
the parking brak e .
2. Stop the engine , remo v e the k ey , and w ait for
all mo ving par ts to stop before lea ving the
operating position.
3. After adjusting the height-of-cut, remo v e the
bolt and n ut ( Figure 21 ).
Figure 21
1. Center rollers and spacer 3. Bolt
2. Nut
4. Select a hole so that the center rollers are
positioned to the nearest cor responding
height-of-cut desired ( Figure 21 ).
Note: Do not adjust the rollers to suppor t
the mo w er housing .
5. Install the bolt, center rollers , and n ut
( Figure 21 ).
Positioning the Seat
T he seat can mo v e forw ard and bac kw ard.
P osition the seat where y ou ha v e the best control
of the mac hine and are most comfor table .
Important: T o adjust, mo v e the lev er
sidew ays to unlock seat ( Figur e 22 ).
Slide the seat to the desired position and release
lev er to loc k in position.
Figure 22
1. Adjustment lever
21
To Next Page
Loading...