Installing the Filters
Important: T o pr ev ent engine dama ge,
al w ays operate the engine with both air filter s
and co v er installed.
1. If installing new filters , c hec k eac h filter for
shipping damag e . Do not use a damag ed filter .
2. If the safety filter is being re placed, carefully
slide it into the filter body ( Figure 28 ).
3. Carefully slide the primar y filter o v er the safety
filter ( Figure 28 ).
Note: Ensure that it is fully seated b y pushing
on the outer rim of the filter while installing it.
Important: Do not pr ess on the soft
inside ar ea of the filter .
4. Install the air cleaner co v er with the side
indicated as UP facing up and secure the
latc hes ( Figure 28 ).
Servicing the Engine Oil
Service Interval/Specication
Chang e the engine oil as follo ws:
• After the first 8 operating hours
• After ev er y 100 operating hours
Note: Chang e the oil more frequently when
the operating conditions are extremely dusty
or sandy .
Oil T ype: Deterg ent oil (API ser vice SF , SG ,
SH, or SJ)
Crankcase Capacity: 58 ounces (1.7 liter) with
the filter remo v ed; 51 ounces (1.5 liter) without
the filter remo v ed
Viscosity: R efer to the table belo w
Figure 29
Checking the Engine Oil Level
1. P ark the mac hine on a lev el surface .
2. Diseng ag e the PTO , tur n the ignition k ey to
off , and remo v e the k ey .
3. W ait for all mo ving par ts to stop before lea ving
the operating position and then c hoc k or bloc k
tires .
4. Clean around the oil dipstic k ( Figure 30 ) so
that dir t cannot fall into the filler hole and
damag e the engine .
Figure 30
1. Oil dipstick 2. Filler tube
5. Unscrew the oil dipstic k and wipe the end
clean ( Figure 30 ).
6. Slide the oil dipstic k fully into the filler tube ,
but do not thread onto tube ( Figure 30 ).
7. Pull the dipstic k out and look at the metal end.
If the oil lev el is lo w , slo wly pour only enough
oil into the filler tube to raise the lev el to the
Full mark.
29
To Next Page
Loading...