Figure 56
1. Measure here from blade
to hard surface
2. Measure at B and C
7. If the measurements at positions B or C are
not cor rect, loosen the bolt attac hing the rear
c hain to the rear suppor t ar m ( Figure 57 ).
8. Loosen the jam n ut under the rear suppor t
ar m and adjust the adjustment bolt to g et
a measurement of 3-1/8 to 3-1/4 inc hes
( Figure 57 ).
Note: It is recommended that both sides of
the mo w er are adjusted the same distance .
9. Tighten the jam n ut under the rear suppor t
ar m and tighten the bolt securing the c hain to
the rear suppor t ar m.
10. Adjust the opposite side if needed.
Figure 57
1. Rear chain 5. Adjustment bolt
2. Rear support arm
6. Front swivel
3. Bolt
7. Front support arm
4. Jam Nut
Adjusting the Front-to-Rear Mower
Pitch
1. P osition the right blade front-to-rear
( Figure 58 ).
2. Measure the right blade at the A location, from
a lev el surface to the cutting edg e of the blade
tip ( Figure 58 ).
Figure 58
1. Measure here from blade
to hard surface
2. Measure at A and B
3. R ecord this measurement.
45
To Next Page
Loading...