Figure 13
1. PTO—on
2. PTO—off
4. Mo v e the c hok e control to the on position
before star ting a cold engine ( Figure 14 ).
Note: A w ar m or hot engine ma y not require
c hoking . After engine star ts , mo v e c hok e
control to R un position.
Figure 14
1. Choke—on 2. Choke—off
5. Mo v e the throttle control to the F ast position
before star ting a cold engine ( Figure 15 ).
Figure 15
1. Throttle—fast 2. Throttle—slow
6. T ur n the ignition k ey to Star t. W hen the
engines star ts , release the k ey ( Figure 16 ).
Important: Do not enga ge star ter f or
mor e than 10 seconds at a time. If engine
f ails to star t allo w 30 second cool-do wn
period betw een attempts. F ailur e to f ollo w
these instr uctions can bur n out star ter
motor .
Figure 16
1. Off
3. Start
2. Run
7. After the engine star ts , mo v e the c hok e to off
( Figure 14 ). If the engine stalls or hesitates ,
mo v e the c hok e bac k to on for a few seconds ,
then mo v e the throttle lev er to desired setting .
R e peat this as required.
Stopping the Engine
1. Push the PTO to the off position ( Figure 13 ).
2. Mo v e the throttle lev er midw a y betw een the
slo w and fast positions ( Figure 15 ).
3. Let the engine idle for 60 seconds .
4. T ur n the ignition k ey to the off position and
remo v e the k ey ( Figure 16 ).
5. Close the fuel shut off v alv e before transpor ting
or storing the mac hine .
19
To Next Page
Loading...