Removing the Battery
Batter y ter minals or metal tools could shor t
a gainst metal machine components causing
spar ks. Spar ks can cause the batter y gasses
to explode, r esulting in per sonal injur y .
• W hen r emo ving or installing the batter y ,
do not allo w the batter y ter minals to
touch an y metal par ts of the machine.
• Do not allo w metal tools to shor t betw een
the batter y ter minals and metal par ts of
the machine.
Incor r ect batter y ca ble r outing could
dama ge the machine and ca bles causing
spar ks. Spar ks can cause the batter y gasses
to explode, r esulting in per sonal injur y .
• Al w ays Disconnect the negati v e (black)
batter y ca ble bef or e disconnecting the
positi v e (r ed) ca ble.
• Al w ays R econnect the positi v e (r ed)
batter y ca ble bef or e r econnecting the
negati v e (black) ca ble.
1. Diseng ag e the PTO , mo v e the motion control
lev ers to the neutral loc k ed position, and set
the parking brak e .
2. Stop the engine , remo v e the k ey , and w ait for
all mo ving par ts to stop before lea ving the
operating position.
3. Unlatc h the seat and tilt the seat up .
4. First disconnect the neg ati v e batter y cable
and g round wire from the neg ati v e (-) batter y
ter minal ( Figure 40 ).
5. Slide the red ter minal boot off the positi v e
(red) batter y ter minal. T hen remo v e the
positi v e (red) batter y cable ( Figure 40 ).
Figure 40
1. Battery
7. Washer (1/4 inch)
2. Terminal boot
8. Locknut (1/4 inch)
3. Positive battery cable 9. Battery clamp
4. Negative battery cable 10. J-bolts
5. Ground wire
11. Wingnut (1/4 inch)
6. Bolt (1/4 x 3/4 inch)
6. R emo v e both wing n uts (1/4 inc h) securing
the batter y clamp ( Figure 40 ).
7. R emo v e the batter y .
Installing the Battery
1. P osition batter y in the tra y with the ter minal
posts to w ard the engine( Figure 40 ).
2. First, install the positi v e (red) batter y cable to
positi v e (+) batter y ter minal.
3. T hen install the neg ati v e batter y cable and
g round wire to the neg ati v e (-) batter y ter minal.
4. Secure the cables with 2 bolts (1/4 x 3/4 inc h),
2 w ashers (1/4 inc h), and 2 loc kn uts (1/4 inc h)
( Figure 40 ).
5. Slide the red ter minal boot onto the positi v e
(red) batter y post.
6. Secure batter y with J-bolts , hold do wn clamp
and 2 w ashers (1/4 inc h), and 2 wing n uts (1/4
inc h) ( Figure 40 ).
35
To Next Page
Loading...