NOTE:
To adjust carriage up
or down. Pull spring
pin out with one hand
and with the other hand
adjust carriage to desired
location. Release spring
pin into the nearest hole.
MAINTENANCE:
GUIDE RODS:
Clean and lubricate
with a silicone or teflon base lubricant.
NUTS/BOLTS:
Tighten and/or adjust as
needed.
CABLES: Check tension, end fittings,
and coating. Replace if damaged or
worn. Check jam nuts on cable ends.
(NOTICE: NEW CABLES ALWAYS
STRETCH DURING USE. REFER TO
STEPS 26b & 28b FOR ADJUSTING
CABLE TENSION)
SPRING PINS:
Check that spring pins
fully engage the hole when released.
Tighten spring pin nuts as needed.
FRAME:
Wipe down and damp cloth.
GRIPS:
Inspect and replace if they
appear worn or damaged.
For customer service contact Torque
Fitness Customer service at: 763-754-
7533 (8:30 am - 5:00 pm CST). or
1-877-TORQUE5 (1-866-664-9894).
www.service@torquefitness.com
STEP 33
40
To Next Page
Loading...
