Torque TANK - INSPECTION AND LUBRICATION; Routine Inspections; Lubrication Procedures

SPROCKET
SPROCKET
CHAIN
BELT
HANDLE BOLTS
WHEEL BOLTS
18
INSPECTION & LUBRICATION
INSPECTION:
Recommended tire inflation: 20 PSI
Once a month, check for loose bolts on handles,
wheels and weight horns (optional) as indicated.
Tighten if necessary.
Once a month, check that the chain and sprockets are
clean, free of rust, dust and grime. Make sure that the
chain is properly lubricated. If chain is loose,
retighten chain as outlined on page 9.
Once a month, inspect belt. Make sure the belt is not
worn, frayed or loose. Replace belt if worn or frayed.
If belt is loose, re-tension belt as outlined on page 10.
LUBRICATION:
Once a month, the sprockets should be cleaned and
the chain should be lubricated.
RECOMMENDED LUBRICATION: Use a Dry lubrication
for indoor use, and wet lubrication for outdoor use.
Most bicycle shops carry a variety of different
lubricants and can recommend a lubricant based on
the conditions where the TANK will be used.