F-18
User’s Manual
APPENDIX F
◆ In Closed Office environments, work space is separated by floor-to-ceiling
solid walls.
Supported frequency sub-bands
Subject to the radio regulations that apply in your country/region, your Wireless
LAN card may support a different set of 2.4 GHz channels (see Table F-6).
Consult your Authorized Wireless LAN or TOSHIBA Sales office for information
about the radio regulations that apply in your country/region.
Table F-6 Wireless IEEE 802.11 Channels Sets
Frequency Range 2400-2483.5 MHz
Channel ID
1 2412
2 2417
3 2422
4 2427
5 2432
6 2437
7 2442
8 2447
9 2452
10 2457*
11 2462
* Factory-set default channels
When installing Wireless LAN cards, the channel configuration is managed as
follows:
◆ For Wireless clients that operate in a Wireless LAN Infrastructure, the Wire-
less LAN card will automatically start operation at the channel identified by the
Wireless LAN Access Point. When roaming between different access points
the station can dynamically switch to another channel if required.
◆ For Wireless LAN cards installed in Wireless clients operating in a peer-to-peer
mode, the card will use the default channel 10.
◆ In a Wireless LAN Access Point, the Wireless LAN card will use the factory-
set default channel (printed in bold), unless the LAN Administrator selected a
different channel when configuring the Wireless LAN Access Point device.
To Next Page
Loading...
