6-14
User's Manual
POWER AND
POWER-UP MODES
Starting the computer by password
If you registered a password as supervisor or user, you must enter it to start the
computer.
To start up the computer with the password, follow these steps:
1. Turn on the power as described in Chapter 3, Getting Started and the
following message appears:
Password =
2. Enter the password.
3. Press Enter. The computer displays the message below while it starts up.
Valid password entered, system is now starting up.
If you enter the password incorrectly, a buzzer sounds.
NOTE: If you enter the password incorrectly three times in a row, the
computer shuts off. In this case, you must turn the computer back on to
retry password entry.
To Next Page
Loading...
