Using the remote control
Preparing the remote control for use
With the remote control, you can operate your TV, most cable TV
converters/satellite receivers, VCRs, and DVD players together, even if
they are different brands. In addition to operating the TV, the remote
control can operate most cable TV converters, satellite receivers,
VCRs, and DVD players, regardless of their brand. The remote control
is pre-programmed to operate most Toshiba satellite receivers, VCRs,
and DVD players. To control a non-Toshiba device (or a Toshiba device
that the remote control is not pre-programmed to operate), you must
first program the remote control. See "Programming the remote control
to operate your other devices" on the next page.
Installing the remote control batteries
To install the batteries:
1. Open the battery cover on the back of the remote control.
2. Install two "AAA" size batteries. Match the + and - signs on the
batteries to the signs on the battery compartment.
3. Close the battery cover on the remote control until the lock snaps.
Note:
The TV remote control may not operate your
VCR, DVD player, or cable TV converter.
Refer to the owner's manual supplied with
your other devices to see which features may
be available. Additionally, the remote control
for this TV may not support certain features
available on the original remote controls for
your other devices, in which case it is
suggested that you use the original remote
control for the applicable device.
Caution:
, Never throw batteries into a fire.
Notes:
, Be sure to useAAA size batteries.
* Disposeof batteries in a designateddisposal area.
* Batteriesshouldalways be disposedof withthe
environmentin mind.Always disposeof batteriesin
accordancewithapplicablelawsand regulations.
* If the remote control does not operate correctly,
or if the operating range becomes reduced,
replace batteries with new ones.
, When necessary to replace batteries in the
remote control, always replace both batteries
with new ones. Never mix battery types or use
new and used batteries in combination.
, Alwaysremovethebatteriesfromtheremotecontrol
ff theyaredeador if the remotecontrolis notto be
used foran extendedperiodof time.Thiswill
preventbatteryacidfromleakinginto thebattery
cempartmenL
Using the remote control to operate your other devices
To control a cable TV Power
converter/satellite Input (TV)
receiver: Mute (TV)
Channel
Program the remote Numbers
control to recognize the CH RTN
brand of your cable TV (Channel Return)
converter/satellite receiver Channel/\ v
(see "Programming the CBL/SAT
remote control to operate Volume +/- (TV)
your other devices" on Pic Size (TV)
page 15.) The buttons
shown at right will control
the cable TV converter/
satellite receiver.
Press "CBL/SAT" first.
TV/VCR
14
To control a VCR:
Program the remote Input (TV) --
control to recognize Power
Channel
the brand of your VCR Numbers --
(see "Programming the CH RTN
remote control to (ChannelReturn)
operate your other VCR --
devices" on page 15.) Channel/\ v --
The buttons shown at Volume +/- (TV)
right will then control Pic Size (TV) --
the VCR.
Press "VCR" first.
VCR controls --
il
J3W41121A(E) P14-21 14 14/03/2006, 3:33 PM
To Next Page
Loading...
