Toshiba 34HD82 - Using the POP Double-Window Feature

Introduction
Connecting
your TV
Using the
Remote Control
Setting up
your TV
Using the TV’s
Features
Appendix
Index
31
PIC SIZE
EXIT
STOP SOURCE
ADV/
POP CH
ADV/
POP CH
FAV
FAV
PLAY POP
REC TV/VCR REW FF
STILL SWAP
FAVORITE
MENU/
C.CAPT
ENTER
POP CH yz
POP
SOURCE
Main window
POP window
Using the POP double-window feature
The POP (picture-out-picture) feature splits the screen into a double
window that allows you to watch two programs at the same time. The
POP program can come from a TV broadcast or an external source,
such as a VCR.
To display a TV broadcast in the POP window:
1. Press POP to display the POP window.
POP
12
2. Press POP CH yz to change the channel of the POP window.
If the V-CHIP feature is active and you try to watch a TV
program that exceeds your set rating limits, the program will be
blocked (see “Using the V-CHIP menu” on page 34).
POP
BLOCKED
24
To display a picture from an external source in the POP window:
1. Connect the external source equipment (see “Connecting your
TV” on page 7).
2. Select the TV program you want to watch in the main window.
3. Press POP to display the POP window.
4. Repeatedly press SOURCE to select the input source for the POP
window (VIDEO 1, VIDEO 2, or VIDEO 3 only; you cannot
select ColorStream or DVI in POP mode). The current source
will display in purple.
5. You can play a tape as the POP picture, or select a channel for the
POP window using the VCR’s channel keys.
1
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
23456789101112 13 14 15 16 17 18 19
20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35
123456789101112 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35
POP SOURCE SELECT I ON
0 : TV
1
VIDEO
V1 :
2 :
3 :
I DEO
2
VIDEO 3
0 - 3 : TO SELECT
While the above menu is on-screen, you can select the desired
signal input source by pressing the corresponding number button
(0–3).
To close the POP window:
Press POP again.
Note:
• The SOURCE, POP, STILL, and SWAP
buttons on the remote control operate the
TV’s POP features.
• You cannot access POP features when
viewing ColorStream HD1/HD2 or
DVI/HDCP input.
• You cannot display the ANT-2 signal source
in the POP window.
• You can output the sound of either the
main or POP program from the Audio OUT
jacks (see “Selecting the Audio OUT
sound” on page 48).
NOTICE OF POSSIBLE ADVERSE
EFFECTS ON TV PICTURE TUBE
Avoid displaying stationary images on
your TV screen for extended periods of
time. Fixed (non-moving) images (such
as still PIP/POP windows or black/gray
bars in wide-screen picture or PIP/POP
formats) can become permanently
engrained in the picture tube. This type
of damage is NOT COVERED BY
YOUR WARRANTY because it is the
result of misuse. See item 32 on page 4.
(Continued on next page)