Toshiba 34HD82 - Adjusting the Sound; Muting the Sound; Selecting Stereo;Sap Broadcasts

Introduction
Connecting
your TV
Using the
Remote Control
Setting up
your TV
Using the TV’s
Features
Appendix
Index
45
Adjusting the sound
Muting the sound
Press MUTE to temporarily reduce (1/2 MUTE) or turn off
(MUTE) the sound. While the sound is off, the screen will display
“1/2 MUTE” or “MUTE” in the lower right corner. Each time you
press MUTE, the mute mode will change in the following order:
→ Normal → 1/2 MUTE → MUTE
When you press MUTE, the closed caption feature is automatically
activated. To deactivate this feature, press MUTE again. This feature
works only when the closed caption mode is set to OFF. See “Using
the closed caption feature” on page 43 for more information.
Selecting stereo/SAP broadcasts
The multi-channel TV sound (MTS) feature allows you to listen to
high-fidelity stereo sound while watching TV. MTS also can transmit
a second audio program (SAP) containing a second language, music,
or other audio information (when provided by individual stations).
When the TV receives a stereo or SAP broadcast, the word
“STEREO” or “SAP” appears on-screen every time the TV is turned
on, the channel is changed, or the RECALL button is pressed.
The MTS feature is not available when the TV is in VIDEO mode.
To listen to stereo sound:
1. Press MENU, and then press x or • until the AUDIO menu
appears.
2. Press y or z to highlight MTS.
3. Press x or • to highlight STEREO.
1
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
234567891011 12 13 14 15 16 17 18 19
20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35
AUD OI
MTS
BASS
STEREO SAP MONO//
50
50
0
TREBLE
BALANCE
RESET
You can leave your TV in STEREO mode because it will
automatically output the type of sound being broadcast (stereo or
monaural). The word “STEREO” or “SAP” displays in yellow in
the menu when the TV receives the signal.
If the stereo sound is noisy, select MONO to reduce the noise.
To listen to SAP (if available):
1. Press MENU, and then press x or • until the AUDIO menu
appears.
2. Press y or z to highlight MTS.
3. Press x or • to highlight SAP. You will hear the station’s second
audio program (if available) from the speakers, while viewing the
original picture (see note at right).
123
456
789
ENT
100
0
CH
VOL
POWER
TIMER
RECALL
TV/VIDEO MUTE
TV
CABLE
VCR
CH RTN
PIC SIZE
EXIT
LIGHT
STOP SOURCE
ADV/
POP CH
ADV/
POP CH
FAV
FAV
PLAY PIP
FAVORITE
MENU/
C.CAPT
ENTER
RECALL
MUTE
Note :
A second audio program (SAP) can be heard
only on those TV stations that offer it.
For example, a station might broadcast music
as a second audio program. If you have SAP
on, you will see the current program on the
screen but hear music instead of the
program’s normal audio.
However, if you have SAP on, and the
station you are watching is not currently
broadcasting a second audio program, you
will see the picture but not hear any sound.
If this happens, put the TV in STEREO mode
so you can hear the station’s normal audio.
yzx •
MENU