Toshiba 40PU200 series - Connecting Audio Systems; Digital and Analog Audio Outputs; Connecting Amplifiers with Dolby Digital

• o HDMI 1 (input terminal) — High-De nition
Multimedia Interface input receives digital audio
and uncompressed digital video from an HDMI
device.
• o HDMI 2 (input terminal) — High-De nition
Multimedia Interface input receives digital audio
and uncompressed digital video from an HDMI
device or uncompressed digital video from a DVI
device (Connect HDMI, DVI or PC etc.).
• o PC/HDMI 2 (AUDIO) (input terminal) —
PC audio input terminal is shared with HDMI
analogue audio input terminal, and their use can
be con gured in the SETUP menu (Connect PC or
DVI etc.).
• A (aerial input terminal) — Analogue aerial
signal input.
• o (1) COMPONENT / VIDEO INPUT (input
terminals) — High-de nition component video
and standard (analogue) stereo audio inputs, or
standard (composite) video and standard stereo
audio inputs.
• o (2) (video 2 input terminal) — Standard video
and standard stereo audio input.
• o RGB/PC (input terminal) — For use when
connecting a personal computer (PC) (Connect PC
etc.).
• O AUDIO (output terminals) — Standard audio
outputs.
Notes:
• Before connecting any external equipment, turn o
all main power switches.
• The unauthorized recording of TV programmes,
DVDs, video tapes and other materials may infringe
upon the provisions of copyright law.
• o COMPONENT / VIDEO INPUT terminals
Red
(Audio)
White
Green
Blue
Red
Red
White
Yellow
Y
P B /C B
P R /C R
L/
MONO
AUDIO
R
COMPONENT/
VIDEO INPUT
(1)
VIDEO
Y
P B /C B
P R /C R
L/
MONO
AUDIO
R
COMPONENT/
VIDEO INPUT
(1)
VIDEO
Standard mode Component mode
Connecting an audio system
You can enjoy high quality dynamic sound by
connecting the TV to an audio system.
Notes:
• DO NOT connect the DIGITAL AUDIO output
terminal to the AC-3 RF input of a Dolby Digital
Receiver with a built-in Dolby Digital decoder.
• Connect the DIGITAL AUDIO output terminal to the
OPTICAL input of a receiver or processor.
• Refer to the owner’s manual of the connected
equipment as well.
• When you connect the TV to other equipment, be
sure to turn o the power and unplug all of the
equipment from the wall outlet before making any
connections.
• The output sound of the TV has a wide dynamic
range. Be sure to adjust the audio ampli er’s volume
to a moderate listening level before turning on the
power. Otherwise, the speakers and your hearing
may be damaged by sudden high volume audio.
• Turn o the ampli er before you connect or
disconnect the TV’s power cord. If you leave the
ampli er power on, the speakers may be damaged.
Warning:
When you are connecting (via the DIGITAL AUDIO
output terminal) an AV decoder that does not have
Dolby Digital decoding function, be sure to set PCM for
Digital Audio Output menu (- page 16). Otherwise,
the speakers and your hearing may be damaged by
sudden high volume audio.
Connecting an ampli er equipped with a Dolby Digital
decoder
To Digital Audio
output terminal
To Optical type
digital audio input
Optical digital cable
(not supplied)
Amplier equipped with
Dolby Digital decoder
Front speaker Surround speaker Sub woofer
Centre speaker Signal ow
TV back view
You can enjoy dynamic realistic sound by
connecting the TV to an ampli er equipped with a
Dolby Digital decoder or Dolby Digital processor.
When using this setup, select Auto in the Digital
Audio Output menu (- page 16).
– 8 –
233240PU200SeriesEN0620.indd8233240PU200SeriesEN0620.indd8 2012/06/268:04:412012/06/268:04:41