Toshiba 40XV700A - Programming Channels into; The Tvs Channel Memory; Auto Tuning

16
Notes :
• The same menu is displayed in DTV (Digital TV)
and ATV (Analogue TV) modes; however, some
items are greyed out in each case.
• In video input mode (
o
1
-
o
4
and
HDMI
),
Auto
Tuning
,
ATV Manual Tuning
,
DTV Manual Tuning
,
Quick Setup
and
DTV Settings
are not available.
(
-
page 31).
• If you do not make a selection for a while, the menu
display disappears automatically.
• If you want to close the menu display instantly,
press
P
or
MENU
.
• To return to the previous menu, press
T
.
• In PC input mode,
PC Settings
is available in the
Display Settings
menu (
-
page 44).
• When the
3D Colour Management
function is set
to on (
-
page 24), you can select
Base Colour
Adjustment
in the
Advanced Picture Settings
menu.
Programming channels into the
TV’s channel memory
Auto Tuning
Auto Tuning
will completely re-tune the TV and can be
used to update the channel list�
It is recommended that
Auto Tuning
is run periodically
to ensure that all new services are added� All current
channels and settings, e�g� favourites and locked channels,
will be lost�
Note:
As new services are broadcast, it will be necessary
to retune the TV in order to view them.
1
Press
MENU
, and then press
v
or
w
to select the
SETUP
menu�
SETUP
Menu Language
Country
Auto Tuning
ATV Manual Tuning
DTV Manual Tuning
Location
DTV Settings
Germany
Antenna
Quick Setup
English
Auto
2
Press
s
to select
Auto Tuning
, and then press
Q
�
A screen will appear warning that previous settings
will be deleted�
Auto Tuning
Previous settings will be lost! EXIT for no
change.
DTV and ATVTuning Mode
7MHz
Bandwidth
Start Scan
3
Use
v
or
w
to select
DTV
and
ATV
,
DTV
or
ATV
�
Then, press
s
to select
Start Scan
, and then press
Q
to continue with the
Auto Tuning
�
Press
s
to select
Bandwidth
, press
v
or
w
to select
7MHz, 8MHz
or
7MHz and 8MHz
(
-
page 60)�
The TV will start to search for all available DTV and/
or ATV services�
You must allow the TV to complete the search� When the
search is complete, the
Auto Tuning
screen will display
the services found�
4
Use
s
or
r
to move through the list to select a
channel, and then press
Q
to view�
ATV Manual Tuning
- analogue -
Use the Manual Tuning operation if desired channels
cannot be preset by Auto Tuning or if you would like to
presetchannelstospecicpositionnumbersonebyone.
1
From the
SETUP
menu, press
s
or
r
to select
ATV
Manual Tuning
�
2
Press
Q
to display the
ATV Manual Tuning
menu�
Press
r
or
s
to select the position you want to set�
Pos. Label
ATV Manual Tuning
1
2
3
4
6
7
8
5
3
Press
Q
to display the settings menu� Press
v
or
w
to select an item, and then press
r
or
s
to set the
item as shown below�
Position
ATV Manual Tuning
1
B/G
A 0
A C E
B D F
G
A. Position selection
B. System (Sound)
B/G
,
D/K
,
I
or
M
Getting started