Toshiba 40XV700A - Page 23

23
Using the TV’s features (General)
•
PC
mode is available in RGB/PC input mode or
HDMI input mode.
• The picture mode you select affects the current
input only. You can select a different picture mode
for each input.
1
From the
PICTURE
menu, press the
s
or
r
to
select
Picture Mode
2
Press
v
or
w
to select the
Picture Mode
you prefer
and press
Q
�
Activating the picture preferences
You can customise current
Picture Mode
settings as
desired� For example, while selecting "
Dynamic
," if
you change the following items, such as
Backlight
,
Contrast
,
Brightness
,
Colour
,
Tint
,
Sharpness
and the
Advanced Picture Settings
items, your new
setting are saved for "
Dynamic
"
Picture Mode
�
1
From the
PICTURE
menu, press
s
or
r
to select
either
Backlight
,
Contrast
,
Brightness
,
Colour
,
Tint
or
Sharpness
�
2
Press
v
or
w
to adjust the settings�
Note:
Contrast
are not available when
Picture Mode
is
set to
AutoView
.
Resetting the Picture Mode
This feature resets all picture settings to the factory
settings
Picture Mode
�
Note:
If no picture settings have been changed,
Reset
is
not available.
1
From the
PICTURE
menu, press
s
or
r
to select
Reset
, and then press
Q
�
2
 Aconrmationmessagewillappear.Press
v
or
w
to
select
Yes
, and then press
Q
�
Adjusting Black/White Level
Black/White Level
improves the contrast of the picture�
1
From the
PICTURE
menu, press
s
or
r
until
Advanced Picture Settings
is selected�
0
0
0
0
100
PICTURE
Backlight
Contrast
Brightness
Colour
Tint
Advanced Picture Settings
Sharpness
0
Reset
70
PICTURE
2
Press
Q
, and then press
s
or
r
to select
Black/
White Level
�
7
0
100
PICTURE
Base Colour Adjustment
Colour Temperature
Auto Brightness Sensor Settings
LED Backlight Control
Black/White Level
Noise Reduction
Static Gamma
3D Colour Management
Advanced Picture Settings
Off
Middle
3
Press
v
or
w
to adjust the settings as required�
Using ClearFrame 100Hz
This function eliminates motion blur without adding
ickerorreducingimagebrightnessandimprovesthe
viewing quality of a motion picture�
1
From the
Advanced Picture Settings
menu, press
s
or
r
until
ClearFrame 100Hz
is selected�
2
Press
v
or
w
to select
On
or
Off
�
Adjusting Film Stabilization
The
Film Stabilization
function improves motion
smoothness�
1
From the
Advanced Picture Settings
menu, press
s
or
r
until
Film Stabilization
is selected�
2
Press
v
or
w
to select
Off
,
Smooth
or
Standard
�
Adjusting the Colour Temperature
Colour Temperature
increases the ‘warmth’ or
‘coolness’ of the picture by increasing the red or blue tint�
1
From the
Advanced Picture Settings
menu, press
s
or
r
to select
Colour Temperature
, and then
press
Q
�
2
Press
v
or
w
to select the
Colour Temperature
setting (0 (warm) - 10 (cool))�
70
100
0
0
0
0
PICTURE
Picture Mode Standard
Reset
Backlight
Contrast
Brightness
Tint
Colour
Sharpness