Toshiba 42C3000A - Tuning the TV for the First Time; Programming Channels

To Next Page

To Previous Page

Getting started

Tuning the TV for the first time

- digital only -

Before switching on the TV, put your decoder and media

recorder to Standby if they are connected and ensure the

antenna is connected. To setup the TV use the buttons on the

remote control as detailed on page 10.

1 Press , the Welcome screen will appear. This screen

will appear the first time that the TV is switched on and

each time the TV is reset.

2 Press Q to proceed.

3 The Select Location screen will appear. Press  or 

to select the state in which you live.

4 Press Q to start tuning. The Auto Scan screen will

appear and the TV will automatically start to search for

available stations. The progress bar will move along the

line.

5 When the search is completed, the TV will automatically

turn to the lowest logical channel number. See the

following for more details on Auto Scan.

Note:

If you do not live in Australia, press P at the Select Location.

Press M, then press  or  to select PROFILE.

Press  or  to select Time Zone to set your time zone

(- page 24).

Then use Manual Scan to start tuning (- page 14).

Programming channels into the

TV’s channel memory

Auto scan - digital only -

As new services are broadcast, it will be necessary to re-tune

the TV in order to view them.

Auto scan will completely re-tune the TV and can be used to

update the channel list. It is recommended that Auto scan is run

periodically to ensure that all new services are added. All

stored programs and settings, including Timer entries,

favorites and locked programs, will be lost.

1 Press M and  or  to select the SCAN menu.

2 Use  to select Auto Scan.

3 Press Q. If Password Status (- page 29) is

Enabled, Password menu will be displayed. Enter

your password using the number buttons or press 0000

(which is the default password).

4 The Select Location will appear. Current location will

be highlighted. Press  or  to select a state in which

you live.

5 Press

Q a confirmation screen will appear indicating

that All existing channels will be deleted.

Continue? select Yes.

6 Press Q to start Auto tuning.

The above sample display shows Auto Scan in progress.

The channel number is shown as “06-0007” etc., where

“06” is the physical channel number and “0007” is the

logical channel number (which is the 4-digit number you

enter when changing channels).

7 When the search is complete, the TV will automatically

tune to the lowest logical channel number.

Thank you for choosing TOSHIBA television.

First you need to tune in your television.

Please ensure aerial is connected before proceeding.

Press to continue.

Select Location

Australian Capital Territory

New South Wales

Northern Territory

Queensland

South Australia

Tasmania

Victoria

Western Australia

Back Watch TV

EXIT

Select Function

Auto Scan

7 Digital

7 Digital HD

7 Digital 1

7 Digital 2

Channel 6 found...

06-0007

06-0070

06-0071

06-0072

7 Digital 3

06-0073

7 Digital Guide

06-0077

Scan Status

6/69

Scan Percentage

Back Watch TV Select Function

Password

Watch TV

Blocking active

Enter PIN code

To temporarily unblock

Back