Toshiba 42WP48A - MTS (Multi-Channel TV Sound) Setting; Selecting the Dual 1 or Dual 2 Mode

25
Introduction
Getting started
Basic operation
Using TV’s features
Equipment
connections
Reference section
Viewing teletest
Setting the MTS mode:
Auto mode
The MTS Auto mode automatically recognize stereo/bilingual
programs depending on the broadcast signal.
Press the MENU button, then
press the or button to
display the SOUND menu.
Press the or button to
select MTS.
Press the or button to
select Auto or Mono.
Mono mode
If you experience noise or poor reception of any stereo/bilingual
program, set the MTS mode to Mono.
Noise will be reduced and reception may improve.
Note:
If you experience noise with a particular program on whose channel
reception is usually good, try setting MTS mode to Auto, then press
the
button to Mono (monaural) (see page 26).
Selecting the Dual 1 or Dual 2 mode
You can hear only Dual 1 or Dual 2 sound selected, whenever
bilingual programs are received.
Press the MENU button, then press the or button to
display the SOUND menu.
Press the or button to select
Dual, then press the
or
button to select Dual 1 or
Dual 2.
Notes:
• When the MTS setting is in Mono mode, the Dual menu is not
selectable.
• The Dual menu setting status remains even if the TV is turned off.
MTS (Multi-channel TV Sound) setting
DVD
MENU
P
P
21 3
54 6
87 9
VCR
TV
DVD
0
OK
CALL
MENU EXIT
MENU Back Watch TVEXIT
Bass
0
0
On
SOUND
Speaker
Balance
Treble
0
Auto
MTS
MENU
Back Watch TV
EXIT
0
SOUND
Speaker
Balance
Treble
0
On
MTS
Auto
Dual
Dual 1