2 - 4 2 - 4
MELSEC-A
2 SYSTEM CONFIGURATION
POINT
For use in the remote net ver. 2 mode or remote net additional mode, the master
module of QJ61BT11N and the peripheral software package of GX Developer
Version 8.03D or later are required.
For more information on the applicable modules (CPU modules, network modules)
and applicable software packages, refer to the CC-Link System Master/Local
Module User's Manual (Details) QJ61BT11N.
(3) Restrictions on use of CC-Link dedicated instructions (RLPA,
RRPA)
The CC-Link dedicated instructions may not be used depending on the PLC CPU
and master module used.
For details of the restrictions, refer to the A series master module user's manual,
and the Programing Manual type AnSHCPU/AnACPU/AnUCPU/QCPU (A mode)
(Dedicated Instructions).
This module does not allow the use of the dedicated instructions other than
RLPA and RRPA.
Refer to Section 5.5 for a program example using the dedicated instructions
(RLPA, RRPA).
To Next Page
Loading...
