4
1.3 Installing the Supply Holder Unit onto the Supply Holder Frame
1. Insert the assembled Supply Holder Unit into the rear notches of the Supply Holder Frame as shown in the
diagram below.
2.
Now feed the media from the bottom of the media roll into the media slot at the rear of the printer as shown
.
Rear Notch
The reassembled Supply Holder Unit and media roll may be quite heavy, so be careful not to pinch
your fingers when installing the Supply Holder Unit onto the Supply Holder Frame.
ATTENTION!
Après remontage, le support media et son media peuvent être assez lourds, aussi faites attention à
ne pas vous pincer les doigts lors de l’installation.
NOTE:
Make sure that the brass bushings of the
Supply Shaft are seated into the notches so
that the entire Supply Holder Unit rotates
smoothly.
Supply Holder
Frame
Brass Bushing
To Next Page
Loading...
