Toshiba B-852 Series User Manual

1
TOSHIBA Thermal Printer
B-852 Series
SUPPLY LOADING INSTRUCTIONS
This sheet contains only the media and ribbon loading procedures. Please be sure to read the Owner’s Manual in
the CD-ROM for further information about this printer.
1. LOADING THE MEDIA
1.1 Assembling the Supply Holder Frame
1. Assemble the Supply Holder Frame (L) and Supply Holder Frame (R) to the Supply Holder Base using the
two M-4X6 Wing Bolts supplied, as shown below.
1. Do not touch any moving parts. To reduce the risk of fingers, jewellery, clothing, etc., being drawn into the
moving parts, be sure to load the media once the printer has stopped moving completely.
2. The Print Head becomes hot immediately after printing. Allow it to cool before loading the media.
3. Care must be taken not to pinch your fingers when opening or closing the Top Cover.
4. Be careful not to pinch your fingers by the Supply Holder Frame or Media Holders when loading the media.
AVERTISSEMENT!
1. Ne touchez pas aux éléments en mouvement. Pour éviter les risques que les doigts, les bijoux les
habits, etc. soient tirés vers les éléments en mouvement, rassurez-vous de charger le média lorsque
l'imprimante est arrêtée complètement.
2. La tête chauffe beaucoup en imprimant. Laissez-la refroidir avant de charger le média.
3 .Prenez garde à ne pas vous pincer les doigts lorsque vous manipulez la capot supérieur ou le capot
coté droit.
4. Prenez garde à ne pas vous pincer les doigts lorsque vous manipulez le cadre support média ou les
guides lors du chargement média.
WARNING!
Supply Holder Base
Supply Holder Frame (L)
Supply Holder Frame (R)
Wing Bolt
NOTE:
Make sure that the two small flanges at each end of the Supply Holder Base fit into the small rectangular holes at the
bottom of the Supply Holder Frames before tightening the Wing Bolts.
! 00TSCC0156603!

Toshiba B-852 Series Specifications

General

Print Method	Thermal Transfer / Direct Thermal
Max Print Width	216.8 mm
Power Supply	AC 100-240V, 50/60 Hz
Print Resolution	203 dpi (8 dots/mm)
Memory	32 MB Flash ROM
Interfaces	USB 2.0, Ethernet, RS-232
Media Type	Roll, Fanfold
Media Thickness	0.06 mm to 0.25 mm (0.0024 inch to 0.0098 inch)
Ribbon Length	600 m
Barcodes	UPC/EAN/JAN, Code 39, Code 93, Code 128
2D Codes	PDF417, Data Matrix, QR Code, Maxi Code

Summary

1. LOADING THE MEDIA

1.1 Assembling the Supply Holder Frame

Assembling the supply holder frame to the supply holder base using wing bolts.

1.2 Installing the Media onto the Supply Holder Unit

Disassembling and reassembling the supply holder unit to install the media roll.

1.3 Installing the Supply Holder Unit onto the Supply Holder Frame

Inserting the assembled supply holder unit into the rear notches of the supply holder frame.

1.4 Loading Media into the Printer

Procedures for opening the top cover and raising the print head block to load media.

Feed Gap Sensor Position Adjustment

Adjusting the sensor to center over the label gap for accurate detection.

Black Mark Sensor Position Adjustment

Aligning the sensor with the black mark on the media for proper detection.

2. LOADING THE RIBBON