Toshiba B-SX6T Series Supply Loading Instructions

3
7. Place the assembled Media Holder onto the Supply Holder Frame, and feed the media between the two Media
Guides.
Turn the Locking Lever of the Media Holder to the “Open” position, and push the Media Holders toward the
centre to place the media at the centre on the Supply Shaft. Then, lock the position of the media by returning the
Locking Levers to the “Close” position.
8. Feed the media until it extends past the Platen.
9. Move the Media Guides inside, causing the media to be automatically centred. Then, tighten the Media Guide
Screws to secure the Media Guides.
Media
Media Holder Frame
Locking Leve
r
Close
Open
NOTE:
Place the bushes of the Supply Shaft into the
notches of the Supply Holder Frame securely.
Bush
Notch
Media Guide
Media Guide Scre
w
Media
Be careful not to pinch your fingers or hands by the Supply Holder Frame or Media Holders when
loading the media.
AVERTISSEMENT!
Prenez garde à ne pas vous pincer les doigts lorsque vous manipulez le cadre support média ou les
guides lors du chargement média.
WARNING!

Toshiba B-SX6T Series Specifications

General

Brand	Toshiba
Model	B-SX6T Series
Category	Printer
Language	English