Programming Channel Memory
The channel memory is the list of TV channel numbers your "IV will stop on when you press the CHANNEL • or • button.
First, use the W/CABLE and CH PROGRAM functions to preset all active channels in your area.
If necessary, arrange the preset channels with the ADD/ERASE functions so that you can tune into only desired channels.
Lt!
CHANNEL •/•
MENU
1 Press POWER to turn on the'IV.
2 Press MENU (then ADV • or V) repeatedly
until "W/CABLE" in the Set up menu is
displayed in purple.
TVICABLE: "TV CABLE
CH PROGRAM
ADD'ERASEbADD ERASE
CH LOCK: 0 0 0 D
LANGUAGE: ,ENGLISH FRENCH
SPANISH
TO SELECT ITEM PUSH ADV
TO CONTROL PUSH - +
,<
ADV •
Channel
Number
ADV •
CHANNEL
MENU
3 Press "<(<) or • (>) until the mode that
corresponds to your TV signal system is
displayed in purple.
"rv: IV broadcasts signals.
(VHF channels 2 through 13 and
UHF channels 14 through 69)
CABLE: Cable "IV signals.
(Cable channels 1 through 125)
TVC&BLE _TV CABLE
OH _ROGRAM
AODERASE bADD ERASE
CH LOCK 0 _ 0
LANGUAGE _ENGLISH FRENC._
SPANISH
TO SELECT ITEM PUSH ADV
TO CONTROL PUSH - +
1 Press MENU (then ADV • or •) repeatedly
until "CH PROGRAM" in the Set up menu
is displayed in purple.
r_TViCABLE : VTV CABLE
CH PROGRAM
ADDERAEE:_AOO ERASE
CH LOC_ 0 0 O
LANGUAGE: bENGLISH FRENCH
SPANISH
TO SELECT ITSI4 PUSH ADV
_TOCONTROL PUSH - ÷
2 Press < (<) or • (>) to start channel
programming. The "IV will automatically
cycle through all the "IV or CABLE chan-
nels depending on the mode selected, and
store active channels in the channel
memory.
3 When channel programming is complete,
you will see the message at the right.
CH PROGRAM
TV
#
15
CCMPLETED
TV 4
4 Press CHANNEL • or • to make sure the channel programming has
been done properly.
8
To Next Page
Loading...
