Toshiba CZ27T31 - Programming Channel Memory

Programming Channel Memory
The channel memory is the list of TV channel numbers your TV will stop on when you press the CHANNEL • or • button.
First, use the TV/CABLE and CH PROGRAM functions to preset all active channels in your area.
Ifnecessary, arrangethe preset channels with the ADD/ERASE functions so thatyou can tune into only desired channels.
CHANNELT/&
5oQ%
YY
MENU •/• •/•
<I/I_-
MENU-
n
b MUTE
®®®
®®®
®®®
¢H
o__ --,&/T
c. 4 CHANNEL
TOSHIBA
TV/CABLE function
l Press MENU until the Setup menu is
displayed on the screen.
2 Press• or• until "TV/CABLE" is
displayed in purple.
3
Press • or • until the mode that corre-
sponds to your TV signal system is
displayed in purple.
TV: TV broadcasts signals.
(VHF channels 2 through 13 and UHF
channels 14through 69)
CABLE: Cable TV signals.
(Cable channels 1through 125)
CH PROGRAM function
1 Press MENU until the Setup menu is
displayed on the screen.
2 Press• or• repeatedlyuntil "CH PRO-
GRAM" is displayed in pmple.
3 Press • or b. to start channel programming.
The TV will automatically cycle through all
the TV or CABLE channels depending on
the mode selected, and store active channels
in the channel memory.
4 When channel programming is complete,
you will see the message atthe fight.
TVIC,_BLE: [TVJCABL£
_IDVE[& TI S_L£CT[4 k. I
_ _ WI_,BLE I
MOV£I& V] SEt.[CT[.,I _.]
,_ ,k_ ¸ % _Bt_
MOVEIA _l STARTI_I P]
CH PROGRAM
CABLE 24
41,
CH PRC_IRAMMI NG
CCMPLETED
CABLE 4
5 Press CHANNEL • or • to make sure the channel programming has
been done properly.
13