Programming the Remote Control
n This Remote Control is preprogrammed to operateTOSHIBA VCR's.
n To use VCR's other than TOSHIBA models (or cable converter), perform the following procedures before
operating.
t
FAVOq WNI_t
TOSHIBA
To control other brands of VCR's and cable TV converters
I Refertothe "VCRcodetable"(or"Cable TVconvertercode
table") on pages 9 and 10 to find the code number that corresponds to the
brand name of your VCR (or converter).
If more than one numberis listed, try each one separately until you find
the one that _vorks.
2 Set the TV/CABLE/VCR switch to "VCR" (or "CABLE").
3 Hold down RECALL while pressing the Number buttons for the three
digit code number for your brand of VCR (or converter).
Point the Remote Conh'ol at the VCR (or atthe converter) and press
POWER to test the code number.
-If the right number was entered, the VCR (or the converter) should
turn off.
-If the VCR (or the converter) does not respond to the Remote
Control, repeatsteps 1to 4 with another code number.
For future reference, write down the code numbersyou used:
VCRCODE
CABLECODE
Notes,*
• You have to reprogram the Remote Control when you change its batteries.
n Some newer VCR's are capable of working on either of two remote codes. These
VCR's have a switch labeled "VCRI/VCR2 ",
If your VCR has this kind of switch, and does not respond to all the code numbers
for your VCR brand name, set the switch to another position ("VCR1 "or "VCR2 ")
and reprogram the Remote Control
8
To Next Page
Loading...