Toshiba CZ27T31 - Preparing the Remote Control for Use

Preparing the Remote Control for Use
With theRemoteControl,youcanoperateyourTV,mostVCRmodelsand cableTVconverterstogether,even if they are
differentbrands.If youwill beusingyourTVwith aToshibaVCR,yourRemoteControlis alreadyprogrammedandreadyto
use.Ifyou owndifferentbrandsof VCRsand/orconverters,youfirsthave toprogramyourRemoteControl.(See
"ProgrammingtheRemoteControl"on page8.)
Installing the Remote Control batteries
1 Slidethebatterycoveroffof thebackof theRemoteControl.
Press and slide to remove.
o +
©
Caution:
• Dispose ofyour batteries in a designated
disposal area. Do not throw your batteries into
afire.
• Do not mix battery typos or combine used
batteries with new ones.
• Remove dead batteries immediately to prevent
battery acid from lealdng into the battery
compartment.
• If you do not intend to use the remote control
for a long time, remove the batteries.
2 Installtwo "AA" size batteries. Match the + and - signs on the batteries to
the signs on the batterycompartment.
©
3 Slidethebatterycoverbackon to the RemoteControluntilthe lock
snaps.
Note:
This Remote Control's functions may or may not
operate your VCR or cable TV converter.
Refer to the owner's manuals supplied with the
equipment to see which features are available. In
addition, the original controllers may have
features not available on this Remote Control If
you would like to continue to use these features,
you may want to use the original remote control
5