57
EN
Introduction Connections
Basic Setup /
TV View Operation
Recording Playback Editing Function Setup Others
You can hide chapters from the title list.
Hidden chapters are skipped during playback.
1 Follow the steps 1 to 3 in “Editing Title Name”
on page 55.
2 Select “Hide Chapter” using [K \ L], then press
[ENTER\OK].
3 Use [SKIP H \ G], [PLAY B] and [PAUSE F]
to decide the chapter to be hidden.
4 Select “Hidden” using [K \ L], then press
[ENTER\OK].
5 Press [RETURN\BACK] repeatedly to exit.
Writing onto the disc starts.
It may take awhile to write the data on a disc.
If you want hidden chapters to be “Visible”, select the
chapter to be shown. Then use [K \ L] to select
“Visible” at the step
4 above.
Data will be written onto the disc momentarily.
Note
• “Hidden” will be displayed in the preview window while
previewing the hidden chapter.
• When you make all chapters in the title “Hidden”, “Hidden” is
displayed in a thumbnail of the title list.
To prevent the accidental editing or erasing of the titles, you
can protect them in the Original menu.
1 Follow the steps 1 to 3 in “Editing Title Name”
on page 55.
2 Select “Protect” using [K \ L], then press
[ENTER\OK].
3 Press [ENTER\OK] again.
Writing onto the disc starts.
It may take awhile to write the data on a disc.
• If the title is already protected, “ON A OFF” will appear
instead. Press [ENTER\OK], to release the title from
protection.
• The protected title will be marked with icon.
4 Press [RETURN\BACK] repeatedly to exit.
Writing onto the disc starts.
It may take awhile to write the data on a disc.
To protect a whole disc
(VR mode DVD-RW and DVD+RW/+R discs only):
Select “Disc Protect OFF A ON” from “DVD Menu”, then
select “Yes”. Refer to “Setting a Disc to Protect” on
page 40.
You can divide a title into two new titles.
1 Follow steps 1 to 3 in “Editing Title Name” on
page 55.
2 Use [SKIP H \ G], [REV E], [FWD D],
[PLAY B] and [PAUSE F] to find where you
want to divide the title.
3 Select “Title Dividing” using [K \ L], then press
[ENTER\OK].
4 Select “Yes” using [K \ L], then press
[ENTER\OK].
The title is divided into two new titles with the same title
names.
5 Press [RETURN\BACK] to exit.
Writing onto the disc starts.
It may take awhile to write the data on a disc.
Note
• You cannot divide a title of the disc when the number of
recording titles reaches the maximum of 99 (-RW) or 49
(+RW), or the number of recording chapters reaches the
maximum of 999 (-RW) or 254 (+RW).
Hiding Chapters
Protecting Titles
DVD+RW
To Next Page
Loading...
Need help?
General
